Materials

The recently developed porous concrete techniques have been tried to apply to not only full-depth concrete pavements for new roads, but also thin bonded concrete overlay for rehabilitation works in Japan. This paper shows their performances as well as their designs and constructions.

In 1999 - in the province of Noord-Brabant in the Netherlands - an eighteen-year-old asphalt road with a cementstabilised fly-ash road-base, appeared to be in bad condition. Further investigation showed that the base was almost completely disintegrated, probably due to bad drainage and due to a possibly low cement content....

Traffic-noise pollution has become an issue for many road authorities. Applying measures at the source i.e. interaction surface and wheel are an effective noise abatement measure and many quiet surfaces have been developed in the last decade. A relative silent surfacing is a concrete surface of exposed aggregates. The Dutch...

A new, reproducible test method for curing compounds has been devised. This method is based on concrete made using 400 kg/m³ of cement and 0/8 granulates. Eight different curing compounds were tested. A linear relation was found between effectiveness after 7 days at 35°C and 40% RH and relative compressive...

The surface (texture) of a concrete pavement has to endure the effects of traffic and the environmental load. At the Technical University of Munich, Institute for Materials and Structures the real stress from solvent, freezethaw and mechanical loads will be simulated in the laboratory as close as possible to practice...

This paper presents a new generation of cementitious material devoted to pavement bedding layer construction and named MACES. This material contains a high volume of water in order to be very fluid and selfcompacting. It has also been designed in such a way that the free water in excess rapidly...

This paper presents results of study on evaluating durability and permeability of porous cement concrete pavement by accelerated loading test at PWRI pavement test track. The following procedure was conducted to evaluate the durability and permeability of porous cement concrete pavement. Three test sections were constructed in 1997. These sections...

The number of roads with concrete surface in Poland is small. During the last few years the cement industry has taken up extensive promoting activities that resulted in increased interest in construction of concrete roads – both motorways as well as local roads. It has turned out that durability of...

In 1998, the Chilean private companies exploiting rock deposits for the aggregate production necessary in the construction industry, promoted the creation of the multilateral Commission with the purpose of solving problems of supply and demand unbalance, uncontrolled environmental impacts and serious legal gaps and/or superpositions. This Commission has been in...

In this paper, portland cement concretes and concretes with blast furnace slag cement were studied to determine the parameters for strength and chloride permeability under different curing procedures. For this purpose, four concrete mixtures were made at two different water cement ratios of 0.45 and 0.65 with cement contents of...

The present study concerns the comparison of the behaviour at high temperature of an asphalt and that of concrete, the purpose being to define the parameters of choice of the material for the construction of roads, in particular in tunnels. To do this, laboratory tests of fire, thermal behaviour and...

Ultra-thin whitetopping is a repair method using concrete for asphalt pavement, whose primary characteristic is to allow the existing asphalt pavement and concrete to perform monolithically as a composite section. The existing asphalt concrete is normally milled to achieve such a bond, but milling can reportedly cause debonding of asphalt...