The present paper aims to contribute to the study of the structural response of concrete slabs jointed by dowel bars in pavements. As is known, a common construction technique of pavements is this one that uses concrete slabs interconnected each other in both directions by equidistant dowel steel bars. A...
Analysis of the Response of Concrete Pavement Slabs Jointed by Dowel Bars
Concrete Pavements for Heavy Traffic Areas
The space available on our roads is becoming less and less. All forecasts agree that the increase in traffic will also cotiliiiue to grow considerably in the years before us. At the same time, because of the changes in political conditions in Europe and the opening of the frontiers, there...
Noise Absorbing Walls
The context resulting from the development of tfansportations and the requirements of a better accoustic confort. Characteristics of the noise: sound speed; accoustic pressure; accoustic diagram; directiveness of the sound; accoustic spectrum. Environment impact of the noise. Comparison of the railway and roadway noise. Most important factors that...
Reconstruction of Bituminous Paved Rural and Urban Roads in the Federal Republic of Germany Using Mix-In-Place Recycling with Cement
Mix-in-Place Recycling with cement stabilization is an economical and environmentally friendly method for the reconstruction of damaged asphalt roads and ways. The most remarkable characteristic of this method is that the entire existing road construction material can be used again for the new road pavement. This essay contains descriptions of...
Urban and Low Traffic Roads Industrial Pavements
In this paper some roads and industrial pavements where "semi-continuous concrete" was employed are prcscntcd as well as cost and performance under several conditions.
Revision of the Austrian Design Method for Standardised Concrete Pavements
The Austrian specification for pavement design also contains standardised construction types for concrete roads. After more than 10 years of experience with the application of these standard pavement types the specification has been revised comprehensively with a special focus on the following objectives: - establishment of an improved method for...
Adjusting the Moisture Content of Mature Concrete for Durability Control
The presence of a specified volume of definite-dispersity air voids in the structure of cement concrete does not quarantee the scaling-resistanceIr concrete pavements under the action of frost and deicing agents. Experiments show that partial drying of mature concrete before its saturation increases the concrete scaling-resistance, while conipleLe dLyirlg up,...
Joint Load Transfer Testing
The paper describes and evaluates plate hearing tests performed on airfield CC slabs, in order to ascertain the interaction of slabs across transverse and longitudinal joints and the joint load transfer. The applied characteristics of mad transfer I .T and T ,TF, varied, however. the great significance of temperature and...
Loading Test on the Surface of Concrete Slabs Cast on Senii-Rigid Base Course
In China, the semi-rigid base materials, with relatively higher strength and modulus, have been widely used in the construction of high-grade roads in the recent decades. However, present specification' for structure design of concrete pavement is based on the results of tests made on the more flexible roadbase. According to...
Test-Methods on Road Concrete with a Very Porous Structure
Research is carried out in the Magnel Laboratory - Ghent University into the properties of road concrete with a very porous structure, enriched with polymer emulsions. The aim of the tests is to optimise the composition of the porous concrete. In this context, the choice of the type of polymer...
A New Geometry of Airport Concrete Pavements
A New Geometry of Airport Concrete Pavements
The French Architectonic Concrete Paving Development
This paper present the good possibilities that we can expect with exposed aggregate concrete surfaces