Design

Exposed aggregate cement concrete (EACC) road pavements are used on a large portion of the Austrian federal motorway network due to their durability and reduced noise emission. The standardized types with 8 and 11 mm chipping sizes have been characterized due to their noise emission and are subject to approval...

This paper presents a structural, functional and economic evaluation model for Jointed Plain Concrete Pavement (JPCP). The model was implemented by using a computer program developed by the authors at the Department of Civil, Building and Environmental Engineering of University of Rome “La Sapienza”. This paper will describe this versatile,...

The metropolitan area of the city of Castellón, situated East of Spain at the Mediterranean coast, has a network of dedicated bus platforms, which was conceived with two main purposes: to enhance public transport and to structure urban development. As a part of this network, a bus platform, 3.9 km...

Since the middle of 90s in Hungary the permanent deformations of semi-rigid asphalt pavements have become a major problem due to increasing traffic and changing climate conditions. It has been a particular challenge concerning the M0 motorway around Budapest exposed to the most serious heavy vehicle traffic. The preceding test...

Concrete, used in the production of highways and pavements, may deteriorate after many years of service, due to severe exposure conditions. Due to strategic and economic importance of such infrastructures, swift action for repair works is required. Repairs with conventional concrete may take long time for gaining adequate strength, where...

Ice and snow on pavement surfaces cost the U.S. national economy in snow removal, damaged pavement and lost man-hours due to travel delay. Common practices for removing ice and snow from pavement surfaces include spraying anti-ice chemicals on the ground and deploying snowplowing vehicles. These methods are labor-intensive, occasionally ineffective...

For many years, the traffic volumes and percentage of heavy traffic on German roads and motorways have steadily increased and this trend is expected to continue in the future. To guarantee mobility in the future, road construction with a maximum service life and a minimum of necessary maintenance are needed....

The Castilla & Leon Regional Government has built a new road between the towns of Castrofuerte de Campos and Toral de los Guzmanes, located in León Province, in the Northwest part of Spain. It includes a 324m long and 10m wide bridge allowing local traffic to avoid a long detour...

As a proposed long-term pavement solution for bus stops and corridors in highly urbanized areas, four experimental short continuously reinforced concrete pavement (CRCP) sections with different percentages of longitudinal steel were built in São Paulo, Brazil. The pavement sections are only 50 meters long each, a short constructive length in...

The authors present the sustainable pavement design solutions applied on 106 km long section of A2 toll motorway in Poland. For this largest infrastructure project, realized in the frame of Public-Private Partnerships (PPP), the concession model, where the concessionaire has to be paid by public part for the accessibility of...

Countries that have little experience in concrete pavement design, application and operation, like Turkey, may face many difficulties while planning of concrete pavement construction (life-cycle, design, cost, technology and equipments etc.). We want to share as follows; managing the project, road map, learning phase, experiences, difficulties, mistakes and best practices...

The longitudinal displacements of the terminus of the continuously reinforced concrete pavement (CRCP) without the terminal anchor lug system were measured and analyzed to investigate the maximum terminal joint width and the necessity of the anchor lug system. The terminal movements under environmental loads were measured at the CRCP sections...