Highways

There is a trend to work with the influence of roads on the whole society. The quality level, and the initial investment cost, for pavements and road superstructures, should therefore be grounded on Life Cycle Cost analysis (LCC). LCC or Whole Life Costing (WLC), is described in a PIARC document...

Concrete, which is susceptible to frost and thawing salts, is protected by adding an air-entraining admixture, which leads to air content levels of 3.5 to 6% being achieved. Another possible protection involves the application of a sealant which prevents water penetration. In this instance, resistance to scaling as a result...

Artificial paving blocks made with portland cement concrete are widespread in many countries. These paving blocks come in various designs such as Interlocking and Italian Flower, and they are produced in special machinery out of rather high quality concrete having about 50 MPa compressive strength. The reason for the concrete...

The paper presents the results of a study about the use of recycled tire and building materials in concrete for “whitetopping” on asphalt concrete paving. This report presents the results of laboratory experiments and field tests. These results were obtained with concretes using substitution ratios of 15% to 20% by...

The fast development of car technology has caused a steady increase in the speed of vehicles and increasingly higher demands on braking and traction. International studies show that every increase in average speed causes increase in personal injury accidents. Yet the present transport infrastructure in general and cement concrete pavement...

The considerable increase of road traffic all over the world increases the demand for traffic surfaces with a longer lifespan and less repairs. When doing maintenance and repair works it is very important to keep short construction times in order to reduce obstruction to traffic to meet this challenge. A...

This paper describes a new rigid pavement constructive method employing hexagonals slabs, being the angle betwen the edges of the slabs at each corner, 120 degrees. This paper is based on the one titled ´´ NEW JOINTS IN RIGID PAVEMENT - HIGHWAY AND AIRPORT´´, of the 8th International Symposium on...

The ‘Drève de Lorraine’ in Brussels is an old forestry road connecting the highway to the south part of Brussels. It has been built in 1925, using concrete slabs of 15 cm thick lying directly on the natural ground. After 78 years of good services, this road has been rehabilitated...

and safety levels for very many years. The Ministry of Transport, Infrastructure and Facilities of the Walloon Region conducted a comparative study of the motorway in 2000 between a continuously reinforced concrete pavement and a bituminous pavement. Very many factors obviously come into play for an objective comparison and they...

Development of new types concrete technology caused an increasing of concrete mixture production with a high proportion of fine filler in recent years. Fine filler is used to ensure required concrete mixture rheology qualities, which are needed to the concrete mixture storage into boarding. There are several materials can be...

The main difference between pavements and other elements made of concrete is the surface property. The surface in concrete pavement must be finished properly. It has been known for a long time that air-entrainment can be used against freezing and thawing deterioration of concrete pavement slabs. In the freeze-thaw attack,...

The study was conducted to bring out the salient features of blended cements, which go a long way in establishing the durability of rigid pavements. Blended cements not only enhance the life cycle of concrete road by protecting it from chloride and sulfate attack but also reduce the thermal cracking,...