Design

The article states that a relative traffic accident risk depends on the values of skid resistance and its durability, which are both influenced by the texturing of Concrete pavements (CP). From the very beginning of the CP construction in the Czech Republic, transverse tining was used for surface texturing. The...

In 2009, an innovative road pavement "Continuous Reinforced Concrete Pavement with Ground Texture" was successfully realised by HeidelbergCement AG with the pilot project, "Geseke access road ". In an extensive measurement programme, long-term measurements are being made over a period of 5 years to investigate the behaviour of the carriageway...

A frequently noted disadvantage of cement concrete pavements is repair time. For further application of this technology, it was necessary to eliminate this disadvantage and significantly reduce repair time. Therefore, Skanska developed the "Fast-setting concrete technology". In-house development commenced in 2005. MC Bauchemie, design engineers and investor representatives also participated....

The Federal Aviation Administration’s (FAA) National Airport Pavement Test Facility (NAPTF) conducts accelerated full-scale testing of airport pavements under controlled conditions. Construction Cycle 6 (CC6) was aimed at evaluating the effects of concrete strength and subbase materials. Two types of isolation joints were also tested for comparison. Data from embedded...

In the last few years at several airports cracking in the internals of concrete gutters has been detected. This was mainly observed, where large airfields (about 60 to 100 m in length) are located next to these drainage lines. In order to reveal the influences on this cracking both laboratory...

As a result of a short mixing time excess air-entraining agent (AEA) is added during the production of air-entrained concrete to achieve the required air content. In this case, the fresh concrete contains AEA that has not been fully activated. If there is a subsequent input of mixing energy, the...

In a life cycle analysis a higher investment cost is justified by lower maintenance costs, less and fewer traffic flow intrusions, and a longer technical life. All these factors contribute to a reduction of the carbon footprint. To further improve the sustainability of PCC pavements the rolling resistance should be...

From both an environmental and economic point of view, the availability and performance capability of infrastructure traffic areas today and in the future is of the highest priority. This applies to both public and private roads and air traffic areas, as well as for busy parking and logistics areas and...

The results of the investigation concerning the loss of skid resistance on Austrian tunnel roads are presented in this poster as well as the results of trials to improve the skid resistance level in the laboratory. Best results were achieved through cleaning the road surface in the tunnel with tailor...

Pavement type selection is often one of the more challenging and controversial decisions highway administrators face. The process involves weighing engineering factors such as materials, structural, and even long term performance against initial and life-cycle costs to help agencies decide between various pavement alternatives. Given the expenditure of significant public...

In the last few years cracking in concrete pavements often is attributed to alkali-silica-reaction (ASR). Although this is a very important aspect other impacts such as traffic loads and restraint stresses due to thermal and hygral effects may not be neglected. In many cases interactions between various causes can become...

For more than ten years tramway structures in Flanders have been built in concrete, particularly those which are subject to traffic loading by trams and city buses. As there has never been a standardized design, a wide range of different solutions have been tried, either in jointed concrete slabs with...